Direct To Film Application and Care Instructions

PRESSING INSTRUCTIONS FOR GARMENTS:

(These are suggested instructions and may vary based on the product you're pressing your transfer to.)

1. Preheat the garment for 15 seconds to remove excess moisture. Let the garment cool before adding the transfer.

2. Place the transfer on the shirt – white side down, image facing up.

3. Press at 305°F for 10 seconds with firm pressure.

4. Remove the garment from the press and let it stand until it is warm enough to peel.

5. Peel warm or cool. A warm peel will result in a matte-looking design. A cool peel will result in a semi-glossy design.

6. Place your garment back on the heat press and cover the image with parchment or butcher paper. Press again for 10 seconds.

**NOTE: If the image does not peel off the transfer easily, place it back under your heat press and press it again. Do not remove the film until the image releases from it completely. 

If you're pressing the transfer to any other substrate, it's going to take trial and error. We suggest pressing any transfer between 305°F and 325°F with firm pressure. 

GARMENT CARE INSTRUCTIONS AFTER APPLICATION: Turn the garment inside out. Machine wash cold. No bleach. No softener. Do not dry clean or iron. Tumble dry low.

TRANSFER STORAGE INSTRUCTIONS: Store your transfers flat in a cool place. Avoid direct sunlight and direct heat until you're ready to press.